Ideal Gas Equation and Gas Laws: notes and previous year questions
The state of a gas, the kelvin scale, Boyle's, Charles's, Gay-Lussac's and Avogadro's laws, PV = nRT, units, density and Dalton's law.
124 JEE Main questions (2017–2026)
7 JEE Advanced questions (2008–2024)
24 NEET questions (2000–2026)
Ideal Gas Equation and Gas Laws in short
A gas is described by its pressure, volume, temperature and amount in moles.
Gas laws always use the kelvin temperature; 0 K = −273.15 °C is absolute zero.
Boyle: at fixed temperature, pressure is inversely proportional to volume, because squeezed molecules hit the walls more often.
Charles: at fixed pressure, volume is proportional to the kelvin temperature.
1Describing a gas
Pump up a bicycle tyre and you push the same air into less space: its pressure rises. In a pressure cooker the lid keeps the volume fixed; as it heats, the pressure climbs, so water boils above 100 °C and food cooks faster. Both are gas laws at work.
Four quantities describe the state of a gas:
PressureP: the push of the gas on each square metre of wall, in pascals (1Pa=1N/m2).
VolumeV: the space it fills, in m3.
TemperatureT: always in kelvin (K).
Amountn: in moles (mol).
As a gas cools its molecules slow down. At −273.15 °C they would have the least possible motion: this is absolute zero, and the kelvin scale starts there. A kelvin step is the same size as a degree Celsius.
T(K)=t(∘C)+273.15Usually rounded to + 273: 27 °C = 300 K, 87 °C = 360 K.
2Boyle's law
Keep the temperature fixed (a cylinder in a water bath) and squeeze the gas. At 6 L the pressure is 1 atm; at 3 L it is 2 atm; at 2 L it is 3 atm. Each time PV=6.
Why: at the same temperature the molecules move just as fast, but in half the space each one reaches a wall twice as often, so every bit of wall is hit twice as often.
P1V1=P2V2Fixed T and n: P ∝ 1/V. P against V is a hyperbola; P against 1/V is a straight line through the origin.
3Charles's law
Keep the pressure fixed (a piston carrying fixed weights) and heat the gas. At 300 K it fills 3 L; at 400 K, 4 L. Extending the straight V–T line backwards, it reaches zero volume at 0 K = −273 °C: this is how absolute zero was first found.
T1V1=T2V2Fixed P and n: V ∝ T (in kelvin).
Why: hotter molecules move faster and hit harder, so the gas spreads out to keep the same pressure.
4Gay-Lussac's law
Keep the volume fixed (a sealed, rigid can) and heat the gas: from 300 K to 450 K the pressure rises from 1 atm to 1.5 atm. The molecules move faster and hit the walls harder and more often.
T1P1=T2P2Fixed V and n: P ∝ T (in kelvin).
Tyre pressure rises on a hot day, and a sealed spray can in a fire can burst. A tyre at 2.0 atm and 27 °C reaches 2.0×330/300=2.2 atm at 57 °C.
The pressure of a fixed box of gas goes up when you heat it at constant volume, squeeze it at constant temperature, or add more gas; it goes down when you let it expand at constant temperature or cool it.
5Avogadro's law
Equal volumes of any gases at the same temperature and pressure hold the same number of molecules, however different their masses. One mole of helium (4 g), nitrogen (28 g) or carbon dioxide (44 g) all fill the same balloon.
n1V1=n2V2Fixed P and T: V ∝ n.
One mole is NA=6.022×1023 molecules.
At STP (0 °C, 1 atm) one mole of any ideal gas fills 22.4 L.
At 0 °C and 1 bar (the newer definition some books use) it is 22.7 L; at 25 °C and 1 atm it is 24.5 L.
6The ideal gas equation
Boyle gives V∝1/P, Charles gives V∝T and Avogadro gives V∝n. Together V∝nT/P, so PV∝nT. The constant is the same for every gas:
PV=nRTR = 8.314 J/(mol K), the universal gas constant.
PV=NkTN molecules; k = R/N_A = 1.38 × 10⁻²³ J/K, the Boltzmann constant.
ρ=RTPMDensity, from n = m/M. M is the molar mass.
T1P1V1=T2P2V2Combined gas law, for a fixed amount of gas.
7Units, density and mixtures
Quantity
Conversions
Pressure
1 atm = 1.013 × 10⁵ Pa = 760 mmHg; 1 bar = 10⁵ Pa ≈ 0.987 atm; 1 mmHg ≈ 133.3 Pa
Volume
1 L = 10⁻³ m³ = 1000 cm³; 1 m³ = 1000 L
Gas constant
R = 8.314 J/(mol K) = 0.0821 L atm/(mol K)
In a mixture, each gas pushes as if it filled the box alone. In a 24.6 L box at 300 K, 2 mol of helium alone gives 2 atm and 3 mol of argon alone gives 3 atm; together they give 5 atm. This is Dalton's law of partial pressures:
P=P1+P2+P3+…Each partial pressure is Pᵢ = nᵢRT/V.
Summary
Key ideas
A gas is described by its pressure, volume, temperature and amount in moles.
Gas laws always use the kelvin temperature; 0 K = −273.15 °C is absolute zero.
Boyle: at fixed temperature, pressure is inversely proportional to volume, because squeezed molecules hit the walls more often.
Charles: at fixed pressure, volume is proportional to the kelvin temperature.
Gay-Lussac: at fixed volume, pressure is proportional to the kelvin temperature.
Avogadro: equal volumes at the same temperature and pressure hold equal numbers of molecules; one mole fills 22.4 L at STP.
All four laws combine into PV = nRT, with the same R for every gas.
Counting molecules instead of moles gives PV = NkT, with k = R/N_A.
The density of a gas is PM/RT.
In a mixture each gas exerts its own partial pressure, and these add up (Dalton).
Choose R to match the units: 8.314 J/(mol K) with Pa and m³, 0.0821 L atm/(mol K) with L and atm.
Real gases depart from the ideal gas equation at high pressure and low temperature.
Every equation
Kelvin
T=t∘C+273.15
Boyle (T, n fixed)
P1V1=P2V2
Charles (P, n fixed)
V1/T1=V2/T2
Gay-Lussac (V, n fixed)
P1/T1=P2/T2
Avogadro (P, T fixed)
V1/n1=V2/n2
Molar volume at STP
22.4L/mol
Combined gas law
P1V1/T1=P2V2/T2
Ideal gas equation
PV=nRT
In molecules
PV=NkT
Boltzmann constant
k=R/NA=1.38×10−23J/K
Gas constant
R=8.314J mol−1K−1
Gas constant (L, atm)
R=0.0821L atm mol−1K−1
Density
ρ=PM/RT
Dalton
P=P1+P2+…
Partial pressure
Pi=niRT/V
Isothermal work
W=nRTln(V2/V1)
Pressure units
1atm=1.013×105Pa=760mmHg
Bar
1bar=105Pa
Litre
1L=10−3m3
Previous year questions with solutions
Real JEE and NEET questions on ideal gas equation and gas laws. Try each one before you open the solution.
Q1JEE Main 2026Numerical answer
An insulated cylinder of volume 60cm3 is filled with a gas at 27∘C and 2 atmospheric pressure. Then the gas is compressed making the final volume as 20cm3 while allowing the temperature to rise to 77∘C. The final pressure is ____ atmospheric pressure.
Show answer and solution
Answer:7
The amount of gas is fixed, so T1p1V1=T2p2V2, with the temperatures in kelvin: 27∘C=300K and 77∘C=350K. The volumes can stay in cm3 and the pressures in atmospheres, since only ratios appear.
p2=p1×V2V1×T1T2=2×2060×300350=7atm
The trap is forgetting the heating: squeezing to a third of the volume alone gives 6atm, and the rise to 350K adds the rest. Putting the Celsius values into the ratio, 2777, gives about 17atm — far too much.
Q2NEET 2026One correct option
A flask contains argon and chlorine in the ratio of 2:1 by mass. The temperature of the mixture is 27∘C. The ratio of root mean square speed of the molecules of the two gases (VrmsClVrmsAr) is:
(Atomic mass of argon =40.0u and molecular mass of chlorine =70.0u )
A27
B47
C27
D72
Show answer and solution
Answer:Option A
The two gases share one temperature, so in vrms=M3RT only the molar mass differs, and vrms∝M1:
vrmsClvrmsAr=MArMCl=4070=47=27
The 2:1 ratio of masses in the flask plays no part: how much of each gas there is does not change how fast its molecules move.
The trap is D, 72, the ratio upside down — it would make the heavier chlorine molecules the faster ones. B, 47, forgets the square root, and C, 27, lets the 2:1 mass ratio in as well.
Q3JEE Main 2026One correct option
An air bubble of volume 2.9cm3 rises from the bottom of a swimming pool of 5 m deep. At the bottom of the pool water temperature is 17∘C. The volume of the bubble when it reaches the surface, where the water temperature is 27∘C, is ____cm3.
( g=10m/s2, density of water =103kg/m3, and 1 atm pressure is 105Pa )
A2.0
B4.2
C3.0
D4.5
Show answer and solution
Answer:Option D
The air in the bubble is a fixed amount of gas, so T1p1V1=T2p2V2. At the bottom it is pressed by the air above the pool and the water: p1=p0+ρgh=105+103×10×5=1.5×105Pa. At the surface, p2=105Pa. In kelvin, T1=290K and T2=300K.
V2=V1×p2p1×T1T2=2.9×1.5×290300=4.5cm3
The trap is C, 3.0cm3, which allows for the warming but forgets that the pressure falls as the bubble rises. B, 4.2, turns the temperature ratio upside down, and A, 2.0, the pressure ratio. A rising bubble must grow: less pressure and more warmth both make it expand.
Practice questions, easy to hard
Three questions from the ideal gas equation and gas laws practice ladder: one easy, one medium, one hard.
Q4Numerical answer
In T1p1V1=T2p2V2 only ratios appear, so pressures may stay in atmospheres and volumes in litres or cm3 — as long as both sides use the same unit. Temperatures are different: they must be in kelvin, because the laws say p and V are proportional to the absolute temperature.
A rigid steel cylinder holds gas at 2.0atm and 27∘C. It is left in the sun until the gas is at 177∘C. What is the pressure now, in atm?
Show answer and solution
Answer:3 atm
The volume is fixed, so Tp is constant. In kelvin, T1=300K and T2=177+273=450K, so
p2=2.0×300450=3.0atm
The trap is using the Celsius values: 2.0×27177≈13atm. A rise from 300 to 450K is only half as much again, and so is the pressure.
Q5One correct option
The molar heat capacity at constant volume, CV, is the heat that warms 1mol of gas by 1K with its volume held fixed. Then all the heat goes into internal energy, so from U=2fnRT,
CV=2fR
At constant pressure the gas expands as it warms and pushes back its surroundings, doing work nRΔT as it does. That takes extra heat, so the molar heat capacity at constant pressure is larger by R:
CP=CV+R (Mayer's relation)
To warm n moles by ΔT takes nCVΔT at constant volume and nCPΔT at constant pressure. Either way the internal energy rises by nCVΔT, because U depends on the temperature alone.
How much heat warms 2mol of helium by 10K at constant pressure? Take R=8.3Jmol−1K−1.
A415J
B249J
C166J
D581J
Show answer and solution
Answer:Option A
Helium is monatomic, f=3, so CV=23R and CP=25R. The heat is nCPΔT=2×25×8.3×10=415J: 249J of it raises the internal energy and 166J goes into pushing back the surroundings.
The trap is B, 249J, which uses CV — right at constant volume, but here the gas also expands. C, 166J, is only the extra part, nRΔT. D, 581J, uses CP=27R, which belongs to a rigid diatomic gas.
Q6Numerical answer
For one gas, vrms=M3RT grows as the square root of the absolute temperature.
The rms speed of the molecules of a gas is 400m/s at 27∘C. What is it at 327∘C? Give your answer to the nearest whole m/s.
Show answer and solution
Answer:565.7 m/s
In kelvin the gas goes from 300K to 600K, which doubles T. So vrms=400×2≈566m/s.
The trap is the Celsius ratio: 400×27327≈1392m/s. Another is forgetting the square root and doubling the speed to 800m/s.